2)Safely remove your engine undertray and keep it safely, then take drain gear oil suitable container keep it non-dust place,make sure correct oil refilling your gearbox.
3)Remove three bolt it is secure right hand drive shaft(most of bolts size here 10mm) using tool like(extension bar and a flexible socket)
4)Remove exhaust from manifold and leave hanging and then remove centre tunnel bolt and again leave hanging by the two rear most bolts which are under the heat shield
5)Remove chassis rails both sides it is fitted on only particular model
6)carefully support the engine, use a piece of wood on the top of our gearbox stand and next remove rear engine mount
7)reverting body secured sub frame bolt and then remove the bolt which one secure the steering rack to the sub frame and then remove the sub frame.
8)Remove both drive shafts from the differential, after remove both gearbox seal carrier and then remove differential casing bolt and take differential out of the car
9)Fit the existing crown wheel to the differential and fit new bearing and clean mating face of the differential housing up then apply sealer.Reassign differential, Fix both gearbox seal carrier and check bearing preload. Load is correct means then remove seal carrier and refit spacer and reassemble your car
No comments:
Post a Comment